Comments on: Jailbreak iPhone 3G OS 3.1.2 Pwnage Tool (Mac)

By: iphonetech

iphonetech — Fri, 01 Jan 2010 15:26:44 +0000

chow,

Carefully follow the steps, that is supposed to happen. Once fully done with the restoration you must check to see if cydia or ice is there. If they are go ahead and restore or iphone from a previous backup therefore your stuff is on it.

By: chow

chow — Thu, 10 Dec 2009 00:04:54 +0000

i used the pwnagetool 3.1.4 on my iphone 3gs 3.1.2 with no problems (i.e. downloading firmware for 3gs 3.1.2, build custom firmware, restore using the cfw) during reboot…my phone showed the pineapple logo for a second and then just went blank…

i had to restore it with the official firmware through i tunes…

it worked, sadly though unjailbroken..

anyone out there who can help?

By: Z

Thu, 05 Nov 2009 04:53:17 +0000

Activate phone is different from unlock. Do ultrasn0w, it should fix your problems.

Activation is so that it lets you use it at all, which usually needs an AT&T sim with an iphone plan ONCE immidiately after you install the firmware. This bypasses that part. Also important for your situation.

After that, with a Tmob sim in it, it will unlock and be a fully-functional iPod Touch. You NEED Ultrasn0w to get phone capabilities with a non-AT&T carrier.

By: Christian

Christian — Sun, 25 Oct 2009 13:11:09 +0000

Hmm, I could need some help now almost giving up . I used 10hours to unlock my iphone now. First I installed Mac osx, so I could use the newest version of pwnagetool. My phone is 3gs with firmware is 3.1.2 from itunes and modem fimrware 05.11.07 The Jailbreak and custom firmware went 100% ok and my phone is running with the custom firmware atm., but my problem is like many others in here : no service I have no signal at all tryed with 3 diffrent careers sim cards , but they all wont get a signal. I have not installed Ultrasn0w cause I already checked : activate phone in pwnage, but something is wrong cause I have no signal. Anyone know what I could be doing wrong ?